The installation failed at the SECOND_BOOT phase with an error during BOOT operation. Thankfully, Microsoft was kind enough to release an official fix for such errors. The workarounds, however, aren’t applicable to all of the cases due to which certain users still face the problem. Therefore, to overcome such obstacles we are here to help you through it. Just go through the mentioned solutions, make sure to follow them all, and you’ll be back on track in no time.
What causes the Windows Setup Error 0xC1900101 – 0x40017?
The error 0xC1900101 – 0x40017 is caused by a number of factors that are mentioned below — Now, to solve your problem, follow the given solutions:
Solution 1: Running the Upgrade a Couple of Times
Sometimes, the upgrade doesn’t kick off as it is supposed to do in which case running the upgrade a couple of times help solve the issue. You can also try to reboot your system and then run the upgrade which, at times, can be the desired solution.
Solution 2: Turn off Windows Firewall
Most of the users have reported that their issue was occurring due to the Windows firewall. It can sometimes interfere with the upgrade process and can potentially prevent you from upgrading. In such a case, you’ll have to disable the Windows firewall. Here’s how: Note: If this doesn’t fix your problem, make sure to keep your firewall off until you have tried the rest of the solutions.
Solution 3: Disconnect External Hardware
In some cases, your external hardware can potentially be the cause of the error. This has been reported multiple times and the workaround is quite straightforward, unplug all the external hardware connected to your system like USB, smartphone, printer etc. Once you’ve done that, run the upgrade again.
Solution 4: Disable Antivirus
If you are using a third-party antivirus, it is very likely to be the cause of the error. This happens quite often i.e your antivirus preventing Windows update or upgrade. If you have a third-party antivirus installed on your system, make sure to disable it before you run the upgrade. It might solve your problem.
Solution 5: Update your Drivers
The error is primarily due to your outdated device drivers. In such a scenario, you’ll have to find the problematic device drivers and then update them. Here’s how to update your drivers:
Solution 6: Free Up Hard Disk Space
When you are upgrading to Windows 10, make sure you have sufficient hard disk space. Windows 10 installation requires at least 16 GB of free space, hence, make sure you have that covered. If not, you’ll have to free up some space. You can follow our guide here to know how to free up space on your system volume.
Solution 7: Perform a Clean Boot
Finally, if none of the above-mentioned solutions work out for you, this solution is bound to work for you. Sometimes, your background processes can be interfering with the system due to which the error is being caused. Hence, to eliminate such possibilities, you’ll have to perform a Clean Boot. A Clean Boot lets you boot into your system using the minimal background services/processes required. Please refer to this article published on our site to know how to perform a Clean Boot. Once you have performed a Clean Boot, run the upgrade — this will most probably solve your problem.
Solution 8: Update BIOS
Some Dell users have reported that they tried several solutions but none worked out for them. Their issue was due to outdated BIOS. Hence, if you are using a Dell system, make sure to update your BIOS before running the upgrade. Please refer to this article that’ll show you how to update Dell BIOS.
Fix: Windows 10 Update Error ‘0xc1900101-0x30018’Fix: Windows 10 Install Error 0xC1900101 - 0x20004Fix Windows 10 Installation Error 0XC1900101 – 0x20017Fix: 0xc1900101 – 0x4000d Error During Windows 10 Installation
